VoIP Settings

PAP2T to Fax

Tuesday, 18 December 2012 22:35
Rate this item
(0 votes)
  NOTE: Set the following parameters under Line 1 or Line 2 tab, depending on what Line the fax is registered to.Step 1: Access the PAP2’s web-based setup page.Step 2: Once the PAP2’s web-based setup page appears, click Admin Login then click switch to advanced view.Step 3: Click Line 1 or Line 2.Step 4: Look for Network Settings set Network Jitter Level to high.Step 5: Go to the Audio Configuration section and set Silence Supp Enable, Echo Supp Enable and No Echo Canceller to no. Set FAX Passthru Method to NSE, FAX Passthru Codec to G711u and Use Pref Codec Only to yes.Step 6: Go to the Supplementary Service Subscription section and set Call Waiting Serv and Three Way Conf Serv to yes.NOTE: If the above settings did not work, please power down the PAP2 and power it on after 30 seconds.Step 3: Click Line 1 or Line 2.Step 4: Look for Network Settings set Network Jitter Level to high.Step 5: Go to the Audio Configuration section and set Silence Supp Enable, Echo Supp Enable…

telecomart

Telecommunications - Electronic Applications
64 Kimonos str. 54453 Thessaloniki Hellas

Tel: 0030 2310 920499
Fax: 0030 2310 920466

www.efarmoges.gr
info(at)efarmoges(dot)gr

FacebookMySpaceTwitterDiggDeliciousStumbleuponGoogle BookmarksRedditTechnorati

Login Form